Ratbot for "Dummies"

1.

Unzip Rbot.zip intoyour Quake2 folderand start  RatBot.exe

Then follow these steps ---»

2.

After you've completed the steps in 1. and pressed the Options button, follow these steps and then press OK ---»

3.

After you've completed the steps in the options section and pressed OK, you return to the main screen. And press Start ---»

4.

After you've started Quake2 follow these steps ---»

»While holding down the "Ctrl" key, press "V", and you should see "connect  (your IP) : (port)"

»Hit return. You will now see the connecting messages. Depending on your connection, your computer, and the server you will have to wait anywhere from 10 seconds to 2 minutes to finally see the map loading, be patient!

»If the map is not found, quit Quake2. Look in the RatBot window - it will tell you where it looked for the map...make sure its copied to where the ratbot was looking! Press Stop on the ratbot window, and Start again  -- repeat the steps in 4.

»Once the map loads you may have to wait again. Patience is they key here! The game starts, and you play as you normally would.

This is a very basic tutorial on how to start your RatBot. Once you have it down, try using the RatCenter, and experimenting with different FOVs. If you are detected as a Ratbot or Zbot, it means that the server has bot detecting software running, and thus the server doesn't want bots, so leave. If you persist you will most likely get banned from the server. Find a server that doesn't prohibit bots.